paper factory messy material squeezing machine

paper factory messy material squeezing machine

Short Description:

This machine adopts the principle of squeeze dehydration, which is to clean plastic film (plastic film, plastic agricultural film mulch, PP woven bag, snake skin bag, space bag, ton bag, thin plastic sheet waste plastic) quickly A device for squeezing out the water in the plastic.


Product Detail

Product Tags

This machine adopts the principle of squeeze dehydration, which is to clean plastic film (plastic film, plastic agricultural film mulch, PP woven bag, snake skin bag, space bag, ton bag, thin plastic sheet waste plastic) quickly A device for squeezing out the water in the plastic. Equipped with rotary screw device, special reducer, fully automatic equipment for squeezing and dewatering plastic film, plastic agricultural film mulch, PP woven bag, snake skin bag, space bag, ton bag, thin plastic sheet waste plastic, etc. . This machine adopts the principle of squeezing dehydration and is equipped with a rotary screw device to squeeze and dehydrate the plastic film. The squeezing and dehydration efficiency is fast and the effect is good. This machine is easy to operate, the squeezing and dehydration effect can reach more than 95%, and the output can be customized according to customer requirements.

1. The unique squeezing dehydration principle solves the difficult problem of traditional film-like plastic dehydration;

2. Good squeezing effect: more than 95% guaranteed;

3. Taiwanese technology, made in China, extremely cost-effective;

4. Mechanical extrusion dehydration, compared with the original hot air drying, greatly saves energy;

This is new type plastic machine, special for plastic recycling and washing line, it can replace the dewater machine, dryer machine,after the film from out of the high friction washing. When making granules,it’s also not need compactor. Will save more machine cost and power.and easy to control.

General design ideas like the below:

1.squeezing machine barrel no necessary to treatment by 38Crmoal,because fricton part is on head.

But need hot treatment.(heating part by 38Crmoal)

2.squeezing machine barrel design, on the surface,the barrel will be drill more small holes.inside hole about 3mm,outside about 6mm.

So this design can ensure not get stuck by material when have high pressure inside.

3.inside of squeezing machine barrel have 5 pcs Keyway,(picture is 300 type,have 6 pcs Keyway),

this Keyway function is ensure make the rawmaterial push ahead by screw.

4.the squeezing machine Screw material must be by 38Crmoal,rigidy high,Good abrasion resistance.

5.squeezing machine screw design by TWO-IN-ONE,using cost lowest.

6.the mould holes of squeezing machine can be adjustable 

 if interesting details,contact to info@zjgrcmc.com


  • Previous:
  • Next:

  • Write your message here and send it to us